Browse By Category
Back to product list
ASNU Series
Model ASNU is a ramp & roller type clutch, non-bearing supported. Bearings are required to support axial and radial loads. Lubrication and sealing are required.
Nominal outer diameter is the same as a Series 63 ball bearing.
- The outer race has positive n6 toler- ance, to give a press fit in a H7 housing . Additional side notches in the outer race provide positive torque transmission.
- If the housing is to K6 tolerance, use of the notches is not necessary, but the housing must be strong enough not to expand after assembly.
- This design can accept an axial misalign- ment of inner and outer race of +/- S/2.
- These clutches are oil dipped at the factory but must be filled to the proper level before operation.
- This clutch is designed for oil lubrication . For grease lubrication, reduce the maximum overrunning speed to 50% of listed value.
Quote Request
If you have any questions regarding the products we are offering, pleasee fill out the form below and one of our representavies will contact your shortly. Thank you for your interest in Drive Line!