Miniature Flexible Clutch Coupling
MINIATURE SERIES
MINIATURE BRAKES, CLUTCHES AND TORQUE LIMITERS
Motion Control Solutions for Tight Spaces, Small Shafts and Light Torque Requirements.
For torque requirements of less than 200 Pound Inches.
For shaft sizes 0.3125 to 0.500 Inch, or 7 to 12mm.
Can be fitted at the factory with pulleys, sprockets or special couplings
Available with sealed housings, and made from corrosion resistant and food grade materials.
AIR ENGAGED FLEXIBLE CLUTCH COUPLINGS
Connect Two Supported Shafts with Slight Angular Misalignment and/or Parallel Offset
Function: Connect, Disconnect
Drive Arrangement: Shaft to Shaft, Slight Angular Misalignment and/or Parallel Offset
Operation
Friction clutch coupling engages with air pressure, spring released when air is exhausted.
Torque is linear in response to air pressure applied.
Mounting
Set screws and customer supplied key connect the clutch mechanism to one shaft and the coupling hub to a second, fully supported shaft.
Anti-rotation arm required to prevent rotation of the air housing.
Clutch couplings are designed for horizontal mounting. If vertical mounting is required, consult engineering for options.
Note: Clutch coupling mechanism DOES NOT support flexible coupling half.
Applications
Flexible clutch couplings connect/disconnect two fully supported shafts.
Maximum RPM varies by model. Please consult the detail sheets (below). Consult engineering if the intended application exceeds the listed maximum RPM.
Design Features
Elastomeric element compensates for up to 3 degrees of angular misalignment and up to 0.040 parallel offset between shafts.
Both clutch mechanism and coupling bored to suit up to the maximum shown (US & Metric) to accept differing shaft sizes.
Low coefficient friction lining versions are available for applications requiring slip or a narrower torque range. Contact engineering for details.
|
Product Code |
Torque @ 80 PSI |
Maximum Bore with Standard Keyway |
Detail Sheet |
|
C2H2R-STH |
190 lb-in |
0.500 in (12 mm) |
|
|
C3H2R-STH |
555 lb-in |
1.000 in (24 mm) |
|
|
C4H2R-STH |
1,317 lb-in |
1.250 in (31 mm) |
|
|
C5H2R-STH |
2,587 lb-in |
1.438 in (38 mm) |
|
|
C5H2K-STH |
3,320 lb-in |
1.438 in (38 mm) |
|
|
C6H2G-STH |
5,397 lb-in |
2.000 in (52 mm) |
|
|
C6H2K-STH |
5,397 lb-in |
2.000 in (52 mm) |
