Browse By Category
  • Back to product list

    MX Series Disc Brake Caliper

    The Twiflex MX13, MX25, MX30 and MX40 series of disc brake calipers are suitable for any industrial disc brake system with disc thickness of 12.7mm, 25.4mm, 30mm and 40mm, respectively. The SMX caliper is only suitable for use with discs 12.7mm thick. Minimum disc diameter is 300mm.

     

    The MX/SMX calipers may be used with any of the Twiflex series of thrusters and feature a patented link mechanism to ensure uniform pad wear.

     

    Normally, one or two calipers are used per disc, but the number may be increased depending on disc size. The brakes may be positioned at any angle around the periphery of the disc, but should ideally be mounted horizontally (i.e. at the 3 o’clock or 9 o’clock position). If the caliper mounting angle is greater than 10° from the horizontal, or on vertical shaft applications, it should be fitted with an inclined mounting kit or equalizing link. A range of brake discs is available from Twiflex (see Disc and Hub Assemblies).

     

    For pneumatic operation use dry, filtered and non-lubricated compressed air. A pneumatic industrial disc brake system requires a control valve, operated either manually or by pneumatic or electrical signal.

     

    The ratings shown on the graphs are based on fully bedded in and conditioned brake pads with a nominal friction coefficient μ = 0.4. A Twiflex industrial disc brake system must be used with Twiflex asbestos free brake pads.

     

    Effective disc radius = actual radius (m) – 0.033m.

    Book a FREE Assessment

    Drive-Line Inc. is proud to have partnered with some of the leading manufacturers of industrial clutches and brakes to deliver you the most advanced motion control solutions available on today’s market.